ahrinn This is awesome. It's the perfect accessory for TR Wheeljack. If I could make one suggestion, it would be to add a tab to the bottom of the monitor piece so it would only open up as far as shown in the render. Mine tends to flop all the way over, though I believe a little bondic or floor polish to tighten the hinge may take care of that.
ahrinn@glaug Ouch. I'll probably have to wait until next payday, but I think the smooth surface would be worth it. Plus I could get your replacement eyes set in frosted to still have the light piping. I'm eager to see how it works out. Thanks!
ahrinn@glaug I've had a couple of TR faceplates printed in it and have been impressed with the detail and sharp lines, plus it is much smoother to the touch than the frosted plastics.
ahrinn Have you considered adding other materials like high definition acrylate?
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: