Click and drag to rotate
Airsoft AUG M-Lok adapter Mk.1 3d printed

DIGITAL PREVIEW
Not a Photo

Airsoft AUG M-Lok adapter Mk.1 3d printed
Airsoft AUG M-Lok adapter Mk.1 3d printed

DIGITAL PREVIEW
Not a Photo

Airsoft AUG M-Lok adapter Mk.1 3d printed Adapter provides 2 M-lok slots on three sides
Airsoft AUG M-Lok adapter Mk.1 3d printed Adapter provides 2 M-lok slots on three sides

DIGITAL PREVIEW
Not a Photo

Airsoft AUG M-Lok adapter Mk.1 3d printed M-lok grip and rail for CQB setup
Airsoft AUG M-Lok adapter Mk.1 3d printed M-lok grip and rail for CQB setup

DIGITAL PREVIEW
Not a Photo

Airsoft AUG M-Lok adapter Mk.1 3d printed
Airsoft AUG M-Lok adapter Mk.1 3d printed

DIGITAL PREVIEW
Not a Photo

Airsoft AUG M-Lok adapter Mk.1 3d printed M-lok bipods on a DMR setup
Airsoft AUG M-Lok adapter Mk.1 3d printed M-lok bipods on a DMR setup

DIGITAL PREVIEW
Not a Photo

Airsoft AUG M-Lok adapter Mk.1 3d printed
Airsoft AUG M-Lok adapter Mk.1 3d printed

DIGITAL PREVIEW
Not a Photo

Airsoft AUG M-Lok adapter Mk.1

$40.78
3D printed in black nylon plastic with a matte finish and slight grainy feel.
QTY

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
This adapter replaces the stock vertical grip on an airsoft AUG and provides 2 M-lok slots at the 3, 6, and 9 o'clock positions. The adapter locks into place with the same pin as the vertical grip. It features the barrel clamp for added stability especially when used with M-lok bi-pods or sling mounts. It is strong enough to lift the rifle with just the vertical grip.

This adapter has been tested with a number of M-lok accessories such as rails, bi-pods, vertical grips, flash-light mounts. High quality M-lok accessories and fasteners are recommended to ensure good retention.

Installation will be much easier with the following tools: Flat 3-4 mm punch, mallet, and screwdriver. The barrel clamp must be separated from the adapter before installation, cut the ring that links the two together. The ring can be discarded. Remove the stock grip by tapping out the pin with a punch and mallet. Install the adapter and make sure the hole on the adapter lines up with the hole on the barrel. The adapter is designed for a very snug fit for stability and may require a few taps with a small mallet to fit into place. Once in place and the retention pin hole is aligned, tap the retention pin into place as well using a punch and mallet as needed. Finally, the barrel clamp requires one screw that is not included; most spare screw from an airsoft gearbox will work.
Details
What's in the box:
RAS2_unibody_1x_linked
Dimensions:
4.71 x 5.26 x 8.37 cm
Switch to inches
1.85 x 2.07 x 3.3 inches
Switch to cm
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.