GCM124 - Soundboard Lightsaber Chassis Var1

For 1.25"ID sabers
Soundboard holder with MultiBoards Adaptive Chassis for:
- NB, Prizm5.1, CF9, Igniter3 (and other NEC equivalent boards)
(An adapter for Teensy Saber V3 is avaialble here.)
(An adapter for ProffieBoard is available here)
(Note for NEC Igniter3 install, the TruDrive board needs to be separated and installed on top - check picture. It makes the length a bit shorter)
- 18650 battery (or 2x16340 for 7.4v install

2 holes available for 4-40 threaded rods (match MHS chassis disk)
2 addition holes for 4-40 threaded rods that match other GCM module lower sizes (from 1.10"OD chassis to 1.14"OD chassis modules)

The soundboard cover comes attached and needs to be cut away. 1.5mmOD rods are then used to hold to cover once install is complete.
Check the picture for the Multiboard Adaptive Chassis cut pattern.

(super glue can be used to secure the chassis module with each other or to lock the modules on the rods. There is also space to use hex nuts on this module)

A separate cover replacement is available to allow a CEx to be installed on top of the CF9 => Here
A battery extension part is also available (with CEx slot) for bigger 7.4v battery pack install => Here