A replacement Matrix-kit for Transformers: Power of the Primes Prime Master figures or Titans Return Titan Master figures. These kits allow for customization of the face while keeping the moving parts and head/body connection from the mass-produced figure for the best fit between head and body.
-
This item is also available in a sprued set with a pair of g2 Smokescreen guns, here.
-
This matrix plate is based on Generation 2 Smokescreen. This is also a suitable face for Smokejumper, Beast Wars 2 Starscrem/Starscream, and Smokesniper.
To offer maximum value under the current Shapeways structure, this item is being offered as a single face under the 'medium' option, and two sprued faces under the 'large.' For most plastics, there is no cost difference between the two.
-
This replacement faceplate connector has been tested using Titan Wars Skullsmasher and Blurr, and should be compatible with most Titan Master mini-figures. As prints vary, some sanding/trimming may be required, and some Titan Masters (like Blurr) lack the rectangular connection peg and gluing may be required to fully secure the face.
-
Some fine details may not show up clearly on prints in strong & flexible plastic.
-
Instructions:
Use a toothpick or pin to remove any support material inside the connector ports on the back of the face.
Paint and seal as desired. Detail plastic prints will need a light washing with soap and water prior to painting to remove support material residue.
Unscrew the screw in the Titan Master's chest. Remove the original face-plate. Place the new face plate on the figure, replace the screw.
The port does not come pre-threaded, so the initial installation will be tight. If the screw connection is too loose you can secure it with a drop of superglue inside the port prior to reinstalling the screw.