Click and drag to rotate
G2 Smokescreen Titan Faceplate 3d printed

DIGITAL PREVIEW
Not a Photo

Gray PA12
G2 Smokescreen Titan Faceplate 3d printed
G2 Smokescreen Titan Faceplate 3d printed

DIGITAL PREVIEW
Not a Photo

G2 Smokescreen Titan Faceplate

Print With Shapeways
Choose Your Size
$10.00
Choose Your Material
Choose your color and finish
QTY

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
A replacement Matrix-kit for Transformers: Power of the Primes Prime Master figures or Titans Return Titan Master figures. These kits allow for customization of the face while keeping the moving parts and head/body connection from the mass-produced figure for the best fit between head and body.
-
This item is also available in a sprued set with a pair of g2 Smokescreen guns, here.
-
This matrix plate is based on Generation 2 Smokescreen. This is also a suitable face for Smokejumper, Beast Wars 2 Starscrem/Starscream, and Smokesniper. To offer maximum value under the current Shapeways structure, this item is being offered as a single face under the 'medium' option, and two sprued faces under the 'large.' For most plastics, there is no cost difference between the two. 
-
This replacement faceplate connector has been tested using Titan Wars Skullsmasher and Blurr, and should be compatible with most Titan Master mini-figures. As prints vary, some sanding/trimming may be required, and some Titan Masters (like Blurr) lack the rectangular connection peg and gluing may be required to fully secure the face. 
-
Some fine details may not show up clearly on prints in strong & flexible plastic.
-
Instructions: 
Use a toothpick or pin to remove any support material inside the connector ports on the back of the face. 

Paint and seal as desired. Detail plastic prints will need a light washing with soap and water prior to painting to remove support material residue. 

Unscrew the screw in the Titan Master's chest. Remove the original face-plate. Place the new face plate on the figure, replace the screw. 

The port does not come pre-threaded, so the initial installation will be tight. If the screw connection is too loose you can secure it with a drop of superglue inside the port prior to reinstalling the screw.
 
Details
What's in the box:
g2-smoekscreen-plate
Dimensions:
1.31 x 1.51 x 0.64 cm
Switch to inches
0.51 x 0.59 x 0.25 inches
Switch to cm
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.