1/700 Scale German Flakpanzer Gepard Self-Propelled Anti-Aircraft Gun x10.
Set contains 10 highly detailed tanks.
Contains:- 10x Flakpanzer Gepard Self-Propelled Anti-Aircraft Guns
Flakpanzer Gepard Self-Propelled Anti-Aircraft Gun
The
Flugabwehrkanonenpanzer Gepard ("anti-aircraft cannon tank Cheetah", better known as the
Flakpanzer Gepard) is an all-weather-capable
German self-propelled anti-aircraft gun (SPAAG). It was developed in the 1960s and fielded in the 1970s, and has been upgraded several times with the latest electronics. It constituted a cornerstone of the
air defence of the
German Army (Bundeswehr) and a number of other
NATO countries. In Germany, the Gepard was phased out in late 2010 to be replaced by "SysFla", a mobile and stationary air defence system using the
LFK NG missile and the new
MANTIS gun system. The mobile platform of SysFla will likely be based on the
GTK Boxer.
The Gepard is also equipped with a Daimler-Benz (type: OM 314) 4-cylinder diesel auxiliary engine for the energy supply system. This engine is on the front left of the vehicle, located where the Leopard 1 has an ammunition magazine. The engine, which has a 3.8 liter capacity, is designed as a multi-fuel engine and produces 66 kW (90 PS). It consumes, depending on the operational status of the tank, between 10 and 20 liters per hour (l/h). The auxiliary engine is coupled with five generators to operate at different speeds: Two Metadyn machines in tandem with a flywheel (which is used to store energy during the acceleration and deceleration of the turret) for the power of the elevation and traverse drives, two 380-Hz three-phase generators with a capacity of 20 kVA for the ventilation, fire control and radar systems, and a 300-A 28-volt direct current generator for the electrical system. The fuel capacity is 985 liters, which ensures a combined operating time of approximately 48 hours.
The chassis and the track were taken directly from the Leopard 1. It has torsion bar spring mounted roadwheels with seven roadwheel pairs per side. They are connected to the torsion bars on swing arms, whose deflection is limited by volute springs. Drive is through the drive sprockets located at the rear. The Rubber-mounted shocks were modified to achieve better stability during firing. The track is manufactured by the company Diehl, rubber track pads fitted, and is "live" track with rubber bushings between the track links and pins (type: D 640 A). Grouser/icecleats can replace the rubber pads on some track links to increase traction on slippery surfaces.
Cleaning Information
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured.
Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended. Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.
Use dedicated model sprue cutters to remove parts to minimise the risk of damage to parts.
Please take a look at my other items.
Painting tips and preparation