M1114 Humvee Armor W/ Spare Tire Bumper and Turret

This conversion kit includes parts to convert a Roco Minitanks Humvee into a more modern, armored variant. You will need a Roco/Herpa humvee kit as a starting point.  Parts included are: main body armor (with slant back and turret), front grill, raised intake, new rear bumper with spare tire holder, spare wheel and tire, and four new 12 bolt wheels.

To use this kit, start by cutting the pieces from the sprue.  Clean and paint all parts in accordance with Shapeways guidance for detailed plastics.  Be careful - especially around the side mirrors, as these parts are delicate.

Main body - you must first shave the area outlined in the attached photo of all raised details such as the rivets, hinges, and air vents. There are also three raised details on top of the bed sides immediately adjacent to the tailgate that need to be shaved. If you are using a Roco body with doors molded on those must also be removed.  There is hole provided at the back, passenger side corner for an antenna.  The area is designed to allow the complete Roco antenna and base to be glue in from the inside.  If desired, you could also fill this hole from the inside using a scrap piece styrene (a .08” strip will fit perfectly).  The body armor then fits over the Roco body.  Clear plastic sheet can be glued to the inside of the body for the windows if desired.  If so, I recommend painting the body parts and gluing on the clear plastic prior to gluing to the Roco body.

Front grill - simply use the new front grill in place of the kit’s front bumper (this also holds the frame the the body).

Extended air intake - simply glue this to the existing air intake.

Rear Bumper - glue this to the existing rear bumper, lining up the holes  for the pintle hook.  Either of the Roco pintle hooks (open or closed) can  be used with this bumper.  NOTE: if you are using the spare tire it is recommended you glue this to the bumper prior to mounting the bumper on the body.

Spare tire - glue this to the new rear bumper.

New wheels - Make sure to thoroughly clean all support material from inside the axle holes (I use a dental pick type tool).   If this is not done, the axles will not insert fully into the wheels.  Once this is done, the wheels simply replace the originals, using the existing rubber tires as well and axles.