This is a set of adapters for Transformers Combiner Wars Motormaster to combine with Legacy Motormaster's Menasor arms. This is sold as a set of 2 adapters, one for each shoulder.
To install, first plug the adapter into Combiner Wars Motormaster's shoulder port. Then Slide the Legacy Menasor Arm into onto the Adapter. You can Install as shown in the pictures or rotate the adapters 90 Degrees for the look of the Legacy Shoulder Joints. I recommend test fitting the parts to each other first before installing onto your figure.
Slits are added to allow for you to grip and separate parts and seprate.
You will need to remove the adapters to transform back into individual robot mode and vehicle mode.
This set will come as 2 pieces. These parts are connected. You will need to separate them and trim off excess plastic with a hobby knife or plastic cutters
This is intended for adult collectors. This is not designed for rough play by children.
This was tested on my home printer, printed in PLA plastic. When fitting the part, press firmly and evenly. Depending on the plastic you choose, sanding or polish may be needed to fine tune the fit. I recommend test fitting the parts before installing onto your Menasor or Motormastor's trailer.
This has been successfully printed in Shapeways Natural Versatile Plastic, Smooth PA12, and Smooth Versatile Plastic,
For the leg extensions for Legacy Menasor, please see my other product here:
https://www.shapeways.com/product/HKATHWFET/tf-legacy-motormaster-thigh-extension-set
For adapters to connect Combiner Wars arms to Legacy Menasor, please see my other product here:
https://www.shapeways.com/product/KDDDTPHYQ/tf-legacy-motormaster-shoulder-adapter-for-cw-limb