You must be logged in and verified to contact the designer.
Product Description
This is a set of adapters for Transformers Legacy Motormaster to combine with Combiner Wars Limb figures as arms. This is sold as a set of 2 adapters, one for each shoulder.
The adapters are made out of 2 parts, a bottom part and a top part. The bottom part provides support from below. The top piece secures the bottom onto the torso. To install, first plug the bottom part of the adapter onto the shoulder from the side. Second, plug the top part of adapter from above. These 2 pieces will form a combiner wars port. I recommend test fitting the parts to each other first before installing onto your figure.
Slits are added to allow for you to grip and separate parts and seprate. I recommend using a precision flathead screwdriver to remove the top part of the adapter.
You will need to remove the adapters to transform back into individual robot mode and vehicle mode.
Update: I made a revision so the parts can be used connected to the trailer for storage when not in Combiner mode. The design still looks the same from the front, but will appear a little different from above and behind.
This set will come as 4 pieces. These parts are connected. You will need to separate them and trim off excess plastic with a hobby knife or plastic cutters
This is intended for adult collectors. This is not designed for rough play by children.
This was tested on my home printer, printed in PLA plastic. When fitting the part, press firmly and evenly. Depending on the plastic you choose, sanding or polish may be needed to fine tune the fit. I recommend test fitting the parts before installing onto your Menasor or Motormastor's trailer.
This has been successfully printed in Shapeways Natural Versatile Plastic and PA12.