A replacement faceplate to convert a Titan Master into Movie Shockwave (or Nitro Zeus, if you prefer this design). This model is available in two versions:
- Medium - A version designed to fit within the normal area of a Titan Master faceplate, this version is flatter but will fit in most helmets/cockpits.
- Large - A slightly larger pack that is more accurately proportioned. May not work with helmets or cockpits.
-
A replacement face-kit for Transformers: Titans Return Titan Master figures and Power of the Primes Prime Master figures. These kits allow for customization of the face while keeping the moving parts and head/body connection from the mass-produced figure for the best fit between head and body.
-
This replacement faceplate connector has been tested using Titan Wars Skullsmasher and Blurr, and should be compatible with most Titan Master mini-figures. As prints vary, some sanding/trimming may be required, and some Titan Masters (like Blurr) lack the rectangular connection peg and gluing may be required to fully secure the face.
-
Some fine details may not show up clearly on prints in strong & flexible plastic.
-
Instructions:
Use a toothpick or pin to remove any support material inside the connector ports on the back of the face.
Paint and seal as desired. Detail plastic prints will need a light washing with soap and water prior to painting to remove support material residue.
Unscrew the screw in the Titan Master's chest. Remove the original face-plate. Place the new face plate on the figure, replace the screw.
The port does not come pre-threaded, so the initial installation will be tight. If the screw connection is too loose you can secure it with a drop of superglue inside the port prior to reinstalling the screw.