A replacement face-kit for Transformers: Titans Return Titan Master figures. These kits allow for customization of the face while keeping the moving parts and head/body connection from the mass-produced figure for the best fit between head and body. This set combines the Optimus Primal Bat/Convobat/Onyx Primal face and the Crocodile Megatron/Megalligator face into a single sprued set.
-
Available individually as Crocodile Megatron and Optimus Primal Bat
-
This replacement faceplate connector has been tested using Titan Wars Skullsmasher and Blurr, and should be compatible with most Titan Master mini-figures. As prints vary, some sanding/trimming may be required, and some Titan Masters (like Blurr) lack the rectangular connection peg and gluing may be required to fully secure the face.Â
-
Some fine details may not show up clearly on prints in strong & flexible plastic.
-
Instructions:Â
Use a toothpick or pin to remove any support material inside the connector ports on the back of the face.Â
Paint and seal as desired. Detail plastic prints will need a light washing with soap and water prior to painting to remove support material residue.Â
Unscrew the screw in the Titan Master's chest. Remove the original face-plate. Place the new face plate on the figure, replace the screw.Â
The port does not come pre-threaded, so the initial installation will be tight. If the screw connection is too loose you can secure it with a drop of superglue inside the port prior to reinstalling the screw.
-