Original length: 138m (assumption, based on the size of the Retellian variant)
Scale: 1/1000
Print orientation for Detail Plastic: Top up
Mounting hole: None
Cost reduction: Hollow, 2mm wall thickness and cut into two parts. Must be glued together.
Requested by: Warrior6
Update Oct. '20: Due to the new "escape hole guidelines" by Shapeways, the old version wasn't printable anymore. This new version has the front containers including the bridge section cut off to create two large openings for cleaning the parts. Also following feedback from some customers, the way it is cut, allows to paint the space between the deflector tube and the bridge section. There are also two pins helping to keep the parts in position and adding stability.
This ship was seen in the episode ENT: "Regeneration" as a Tarkalean Freighter that was attacked by the "Borgified" Arctic One and had large chunks of it cut out. Most probably those parts were used by the Borg as base material to further enhance the Arctic One. The CG model itself was a modified version of the earlier Retellian/Tellarite Freighter model. The basic structure was kept the same but this ship had 2×4 Cargo containers instead of 2×3 on the original model. Also, the bridge section sat a lot lower and the shape of the nose was altered a little. Because i decided that the original Retellian version is in fact a Tellarite design and given the similarity, i also assume this to be a ship built by the Tellarites and the Tarkaleans bought it from them. For the size, i kept the cargo containers and the bridge section the same as on the Retellian variant. The size of that is a rough estimation, based on the
design sketch by John Eaves, where it is depicted alongside an NX Shuttlepod for scale.
If you need this in another material, size, or quantity, send me a message. I will try to make it as you need. Be sure to read
my comments below my shop page first.