Metal Truss for Enduro Axles

IF you're looking to add a little weight down low and stiffen up the axle at the same time, this piece will be the perfect addition to your rig.

Same lower half as our Servo on Axle with Truss, just no servo mount.  We applied some weight saving to the design to keep cost low but maintain strength at the same time.

You'll need 2mm longer screws for the link mounts.  Ideally you'll also use 2xM3 screws and nuts through the truss but it's not mandatory.

Shapeways states a +/- 5% tolerance so some minor sanding may be necessary. We've done a lot of metal parts and shapeways usually nails the dimensions. The 20 day lead time is usually about 2x what it takes. In all of our orders we've only had one take longer than 10 days from order to ship.