Product Description
An attempt at creating a Titan Master who could control the combined force of Devastator with a single, fully effective intellect, Scaffold was unable to interface with combiner tech. Despite this, she joined the Constructicons as a demolitions expert and unofficial mascot. Nothing is more beautiful to her than a newly flattened foundation to build on. Uses her small size and cute appearance to sneak into places the other Constructicons can't get to. When attached to a transtector, can encase its energy-weapon fire into adhesive stasis bubbles she controls by remote, allowing her to use them like demolition charges.
-
Scaffold is an attempt at making a "Rule 63" version of Bonecrusher, suitable as this suggested character or any new character you wish to make her.
-
A replacement face-kit for Transformers: Titans Return Titan Master figures. These kits allow for customization of the face while keeping the moving parts and head/body connection from the mass-produced figure for the best fit between head and body.
-
This replacement faceplate connector has been tested using Titan Wars Skullsmasher and Blurr, and should be compatible with most Titan Master mini-figures. As prints vary, some sanding/trimming may be required, and some Titan Masters (like Blurr) lack the rectangular connection peg and gluing may be required to fully secure the face.
-
Some fine details may not show up clearly on prints in strong & flexible plastic.
-
Instructions:
Use a toothpick or pin to remove any support material inside the connector ports on the back of the face.
Paint and seal as desired. Detail plastic prints will need a light washing with soap and water prior to painting to remove support material residue.
Unscrew the screw in the Titan Master's chest. Remove the original face-plate. Place the new face plate on the figure, replace the screw.
The port does not come pre-threaded, so the initial installation will be tight. If the screw connection is too loose you can secure it with a drop of superglue inside the port prior to reinstalling the screw.