You must be logged in and verified to contact the designer.
Product Description
These brass bracket signal bellcranks have been made available as a replacement if preferred instead of the Frosted Ultra Detail bellcranks supplied with the signal detail parts.
A very fine toothed model saw, motor tool with cutting disc or jewellers fret saw can be used to cut the bellcrank from the sprue. If using a cutting off disc in a motor tool be careful.
The bellcranks have starter holes for the operating wire and these will need to be drilled through with a 0.4mm drill bit. Due to the fineness of the 0.4 drill bit this is best accomplished by hand with a pin vice.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: