1/600 Scale WW2 German Army Turan III Prototype Medium Tank.
Contains 10 highly detailed tanks.
Contains:- 10x Turan III Prototype Medium Tanks
Turan III Prototype Medium Tank
In January 1943, after the mass production of the 41M. Turán II medium tank with the short barreled 75mm L/25 gun has begun, the first combat experiences showed that unfortunately these vehicles did not have enough firepower and protection against the most up-to-date Russian tanks and anti-tank guns either, even after the upgrade from the 40mm cannon of the Turán I. However, the Hungarian troops needed continuous tank replenishment, so the Hungarian Ministry of Defence just could not halt the – more or less still obsolete – Turán II production.At first, to resolve this problem, the Hungarians tried to convince their ally, Germany, to sell manufactured tanks or the production rights for one of their most advanced tank designs, for example the Pz. Kpfw. IV Ausf. H or the Pz. Kpfw. V Panther. Of course, Germany was unwilling to sell manufactured tanks in large numbers to any of their allies, because in 1943, they nearly couldn’t even produce enough combat vehicles for their own purposes. They did not have any advanced tanks to spare.
The first complete 43M. Turán III – also known as Turán 75 hosszú (=long) – prototype with the new turret, increased armor thickness, the long 75mm gun and additional 8mm thick side-skirts was finished in February 1944. However, because of the late war raw material shortage such as the necessary alloy elements and the decrease of production capacity due to the continuous Allied bombing runs against Hungarian industrial areas, no more Turán III tanks were ever created except that prototype even though some sources claim that another 4 or 5 Turán IIs were upgraded (up-armoured) to Turán IIIs, without the long 75mm gun.
Cleaning Information
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured.
Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended. Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.
Use dedicated model sprue cutters to remove parts to minimise the risk of damage to parts.
Please take a look at my other items.
Painting tips and preparation