Lunar Lander Module rev 1

This was a tough model to make since so much is not symmetric, drawings lack detail, and real photos of the Apollo modules vary in features.  I needed almost 500 sketches and features to get it to this detail.  There is a protective cage to prevent shipping damage that should be snipped off the feet after painting.

This model won't fit the smoothest printer at 1/160 or bigger scales.  It is too detailed to print in the versatile plastic.
Rev1 made the landing gear thicker on the 1/400, 1/350, and 6mm scales to meet newer Shapeways requirements.
Painted model shown is 1/400 before the revision and I broke 3 of the 4 the landing gear just clipping it off the support ring.  Should be much stronger but you should clip the ring in 4 before trying to clip it off the landing gear.