Gray PA12
TF Combiner Wars Adapter for Unique Toys War Lord
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$16.98
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Bring your Unique Toys Warlord Figures into the Combiner Wars.
This is a set of adapters for the Unique Toys War Lord Figures to combine with Combiner Wars Torso figures. There are 5 adapters in this set. 2 are for the shoulders ports and 2 are the knee ports, 1 is for the Backpack.
The backpack adapter is designed for the Perfect Effect Torso upgrade kit for Combiner Wars Optimus and Motormaster. However, you could use it to plug the WIng Backpack into any 5mm port.
The 5 adapters are attached to each other. You will need to separate them and trim off the excess plastic with a hobby knife or plastic cutters.
To install, simply slide onto Unique Toys Ports and Slide the other end into the Combiner Wars. The Shoulder and Knee adapters are not specific to any side.
This was tested with my home printer, printed in PLA plastic. When fitting the part press firmly and evenly. Depending on the plastic you choose, sanding or polish may be needed to fine tune the fit.
This has been successfully printed in Shapeways PA12 Plastic.
This is a set of adapters for the Unique Toys War Lord Figures to combine with Combiner Wars Torso figures. There are 5 adapters in this set. 2 are for the shoulders ports and 2 are the knee ports, 1 is for the Backpack.
The backpack adapter is designed for the Perfect Effect Torso upgrade kit for Combiner Wars Optimus and Motormaster. However, you could use it to plug the WIng Backpack into any 5mm port.
The 5 adapters are attached to each other. You will need to separate them and trim off the excess plastic with a hobby knife or plastic cutters.
To install, simply slide onto Unique Toys Ports and Slide the other end into the Combiner Wars. The Shoulder and Knee adapters are not specific to any side.
This was tested with my home printer, printed in PLA plastic. When fitting the part press firmly and evenly. Depending on the plastic you choose, sanding or polish may be needed to fine tune the fit.
This has been successfully printed in Shapeways PA12 Plastic.
Details
What's in the box:
UT To CW Adapter (3)
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
