1/600 Scale Modern Russian T-64A Mod.1976 Main Battle Tank.
Contains 10 highly detailed tanks.
Contains:- 10x T-64A Mod.1976 Main Battle Tanks
T-64A Mod.1976 Main Battle Tank
The
T-64 is a
Soviet second-generation
main battle tank introduced in the early 1960s. It was a more advanced counterpart to the
T-62: the T-64 served tank divisions, while the T-62 supported infantry in motorized rifle divisions. It introduced a number of advanced features including composite armor, a compact engine and transmission, and a
smoothbore 125-mm gun equipped with an autoloader to allow the crew to be reduced to three so the tank could be smaller and lighter. In spite of being armed and armored like a
heavy tank, the T-64 weighed only 38 tonnes (42
short tons; 37
long tons).
These features made the T-64 expensive to build, significantly higher than previous generations of Soviet tanks. This was especially true of the power pack. Several proposals were made to improve the T-64 with new engines, but chief designer
Alexander Morozov's political power in
Moscow kept the design in production in spite of any concerns about price. This led to the
T-72 being designed as an emergency design, only to be produced in the case of a war, but its 40% lower price led to it entering production in spite of Morozov's objections.
Although the T-62 and the famous
T-72 would see much wider use and generally more development, it was the T-64 that formed the basis of subsequent modern Soviet tank designs, such as the
T-80.
In 1976, the weapons system was improved by mounting a D-81TM (2A46-1), stabilised by a 2E28M2, supplied by an automatic 6ETs10M. The night sight was replaced by a TNPA-65 and the engine could accept different fuels, including diesel fuel,
kerosene or gasoline. The production, first carried on the B variant, stopped in 1980.
Cleaning Information
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured.
Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended. Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.
Use dedicated model sprue cutters to remove parts to minimise the risk of damage to parts.
Please take a look at my other items.
Painting tips and preparation