TF TR Fort Max Elbow Swivel Gear

This is a replacement Elbow Gear for your Fortress Maximus/Metroplex.  This is a set of 2.  This is meant to be a direct replacement part for the Swiveling Gear in the Elbow.To install, you will need to disassemble the shoulder/upper arm of your Fortress Maximus/Metroplex. 

1. Remove 4 screws holding together the Shoulder/Upper Arm.
2. Remove the 1 screw holding the gear onto the elbow.
3. Replace the old gear and install the replacement. 
4. Reverse the dissembly instructions to reassemble 

The 2 parts are connected.   You'll need to separate them using plastic cutters or a hobby knife.  Trim off any excess plastic. 

This is intended for adult figure collectors.  This is not designed for rough play by children.

Depending on the plastic you choose, sanding or polish may be needed to fine tune the fit.  

This has been tested with my home 3D printer with PLA Plastic.

For a set of replacement parts for Fortress Maximus' head crest, please see my other product here:
https://www.shapeways.com/product/7CV6GZN87/tf-tr-fort-max-head-crest-replacement?optionId=240394051&li=shops

For the Handle Retainer for Metroplex's Red Cannon, please see my other product here:
https://www.shapeways.com/product/GL3ATCTJX/tf-generations-titan-rifle-handle-retainer?optionId=176624363&li=shops

If you need replacement shoulder ramps for Fortress Maximus, Please see my other product here:
https://www.shapeways.com/product/536632SNH/tf-tr-fort-max-shoulder-replacement-ramp