Case (M3+W1) f. HyperPixel 2.1 Round Touch PiZero
Made by
Digital 3D File 
$19.99
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$44.08
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Wallmount enclosure for pimoroni HyperPixel 2.1 Round Touch* (480x480 pixels (~229 PPI)) and raspberry pi zero with large (17mm) backplate.
collection of cases/parts for this screen
collection of parts for this case
You will need an angled micro USB cable
enclosure in one color:back parts in different sizes:
Check out videos:
If you trust your 3d printer print it by yourself
Important: don't tighten the screws all the way otherwise screen module may peel off from PCB
WARNING: WHEN INSTALLING HYPERPIXEL 4.0 ROUND ONTO YOUR PI MAKE SURE NOT TO PRESS DOWN ON THE SCREEN SURFACE! HOLD THE BOARD BY ITS EDGES AND WIGGLE IT TO MATE WITH THE EXTENDED HEADER (OR GPIO HEADER). ALSO TAKE CARE NOT TO PULL ON THE EDGES OF THE GLASS DISPLAY WHEN REMOVING YOUR HYPERPIXEL.
Buy Me A Coffee: https://www.buymeacoffee.com/printminion
collection of cases/parts for this screen
collection of parts for this case
You will need an angled micro USB cable
enclosure in one color:back parts in different sizes:
Check out videos:
If you trust your 3d printer print it by yourself
Important: don't tighten the screws all the way otherwise screen module may peel off from PCB
WARNING: WHEN INSTALLING HYPERPIXEL 4.0 ROUND ONTO YOUR PI MAKE SURE NOT TO PRESS DOWN ON THE SCREEN SURFACE! HOLD THE BOARD BY ITS EDGES AND WIGGLE IT TO MATE WITH THE EXTENDED HEADER (OR GPIO HEADER). ALSO TAKE CARE NOT TO PULL ON THE EDGES OF THE GLASS DISPLAY WHEN REMOVING YOUR HYPERPIXEL.
Buy Me A Coffee: https://www.buymeacoffee.com/printminion
Details
What's in the box:
m3plus-W1-case-27mm-v47-
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
