White Natural Versatile Plastic
Land Cruiser LC70 MPA front Portal Axle MST CFX-W
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$23.74
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
This is a front axle for 1/10 rc models resembling the Toyota Land Cruiser J7 axle.
Mounts to RC4WD springs - spring track is 71mm instead of 79mm of the RC4WD axle.
Pinion angle is 5° in relation to the spring perches.
Hex to hex width is ~180mm (with 4mm hexes) to better fit under the Killerbody LC70 body.
Designed to use MST MPA internals, c-hubs and reduction boxes.
Righthand shaft will have to be shortened and keyed, left hand shaft can be used as stock.
If used as replacement for the MPA axle, motor direction has to be reversed since the ring gear is flipped.
Updated model: better pinion distance and easer fit for beeftubes.
Axle and 3rd member are printed in one piece and have to be separated.
Clean all parts thoroughly to ensure proper fit and freely working gears - take special care of bearing seat depth!
It is recomended to pre-drill and tap all holes according to the screws used.
7x0,5mm pipe is recomended for use as beef tubes - pre-drill with 7mm drill!
Shim gears if necessary to compensate tolerances.
Mounts to RC4WD springs - spring track is 71mm instead of 79mm of the RC4WD axle.
Pinion angle is 5° in relation to the spring perches.
Hex to hex width is ~180mm (with 4mm hexes) to better fit under the Killerbody LC70 body.
Designed to use MST MPA internals, c-hubs and reduction boxes.
Righthand shaft will have to be shortened and keyed, left hand shaft can be used as stock.
If used as replacement for the MPA axle, motor direction has to be reversed since the ring gear is flipped.
Updated model: better pinion distance and easer fit for beeftubes.
Axle and 3rd member are printed in one piece and have to be separated.
Clean all parts thoroughly to ensure proper fit and freely working gears - take special care of bearing seat depth!
It is recomended to pre-drill and tap all holes according to the screws used.
7x0,5mm pipe is recomended for use as beef tubes - pre-drill with 7mm drill!
Shim gears if necessary to compensate tolerances.
Details
What's in the box:
MPA Axle LC70 front - print
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
