1/72 Scale WW2 German Army Pz.Kpfw. Löwe VK70.01 (K) Heavy Tank x1.
Highly detailed tank with moveable Turret and accurate Track detail.
Comes in 4 parts: Hull, Turret and Wheels/Tracks for both sides. Some assembly will be required.
1x Pz.Kpfw. Löwe VK70.01 (K) Heavy Tank
Pz.Kpfw. Löwe VK70.01 (K)
On 1 November 1941, the general specifications for a super heavy tank in the 70t weight class. The VK70.01(K) was to have 140mm frontal armour and 100mm side armour, with a Daimler-Benz torpedo boat motor rated at 1000hp@2400rpm, a max speed of 43.6km/h was achievable. A crew of five (three in the turret, two in the hull) was requested, with an unspecified main gun, but fully traversable turret.
On 17 December 1941, Krupp requested to develop this vehicle, as they had missed out on the opportunity to develop a vehicle for the VK30.02 Panther. Krupp was asked to design the vehicle with goal of producing a vehicle with armour so strong that no known enemy anti-tank gun could penetrate it. A weight limit of 90 tons was considered, as that was the maximum that railroads could carry.
On 21 January 1942, Krupp presented their conceptual design to Wa Prüf 6. The design featured a 10,5cm KwK L/70 (which was capable of penetrating a 160mm plate at 1000m/30°) in the turret. Wa Prüf 6 informed Krupp they they were to use the new Maybach HL 230 engine rated at 800hp, which was planned to go into production in January 1943.
In February 1942, Wa Prüf 6 pushed the decision to quickly develop two trial 72 ton vehicles with the same drive train and armour as a Tiger, and to go into series production without testing. The 50 Tiefladewagen (low carriage rail cars) that were being produced for the Tiger, could carry this weight.
Krupp was awarded the contract SS 006-6307/42 to produce two prototype VK70.01, one with a turret, and one with a test weight instead of the turret. The name of the project was changed from VK70.01(K) to Panzerkampfwagen Löwe in April 1942.
Development from February 1942 to May 1942 included many designs with varying weight and components.
On 18 May 1942, development of the Löwe ceased, following HItler's decision to produce even heavier tanks. The turret development continued until 20 July 1942, when Wa Prüf 6 ordered Krupp to cease working on the turret.
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured.
Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended. Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.
Use dedicated model sprue cutters to remove parts to minimise the risk of damage to parts.
Please take a look at my other items.
Painting tips and preparation