1Tenth SCX10II 71MM Dual Servo Mount

UPDATED MODEL -  Increased room for servos and lightened it up a little bit.  

Same model as the 74MM just 3MM skinnier. 

When you want to slap a servo winch into your rig, or you're building a custom setup, this is the perfect piece to make it happen. 

Designed to slip into the stock chassis rails but it'll work just fine with any chassis sharing the same bolt pattern.  Mount is 71MM wide so it should work well if aftermarket chassis setups too.

I kept the stock servo location so it'll be a mostly drop in affair.  I suggest widening the front M2.5 hole to a M3 on the stock chassis, not 100% necessary but more screws to grip are better.  If you have an aftermarket 10II chassis it's probably already a M3.  

I kept the design as light as possible  while still beefing it up compared to stock so it'll flex much less.  

Most holes sized to be really snug just be careful not to strip them out.  There's indentions on the bottom for nuts on the servo screws.  If a M3 slides through it should be backed with a nut.