Original length: 600m (
ex-astris-scientia.org, estimation based on a comparison with Voyager)
Scale: 1/2500
Print orientation for Detail Plastic: Top up
Mounting hole: None
Cost reduction: Hollow, 2mm wall thickness and cut into two parts right behind the "neck". Must be glued together. There are two pins to help aligning the two parts. There are additional escape holes hidden behind the main engine in the rear center and behind the overhangs of the front part.
Info: Both warp nacelles on each side are only attached to the main hull at a single point in the rear on the original model. To increase the stability during printing, cleaning and shipping, i added some additional connections between the nacelles and to the hull. Those are 1mm thick wires, like on a sprue. You can remove these afterwards but be warned, the nacelles are really fragile then.
Requested by: alsurfer34
This is the large Hirogen Venatic Class from Star Trek: Voyager. Despite it's huge size, it is only crewed by about 15 to 20 Hirogen Hunter.
If you need this in another material, size, or quantity, send me a message. I will try to make it as you need. Be sure to read
my comments below my shop page first.