This is a TC4 steering hub designed to be used with the TC6 DCV. This is the ultimate drivetrain upgrade for your TC4 giving smooth steering when using a spool.
To use the TC6 DCV and this steering arm/hub, the C-HUB must be dremmeled to remove some meterial. This is unavoudable due to the length of the TC6 DCV.
This hub is designed to take a 5x10x4mm Bearing on the inside and the 5x10x3mm bearing on the outside.
Why use this hub? It does not change the steering geometry on your car like some other hubs may. This hub is designed to match the original steering geometry.
I also recommend the crush tubes between the bearings to prevent the bearings from binding. Full part list needed for conversion
DCV/CVD Hardware
1 set TC6 DCV https://www.amainhobbies.com/team-associated-dcv-kit-asc31632/p273165
2x 5x10x3mm Bearings (outside of the hub) https://www.amainhobbies.com/team-associated-5x10x3mm-tc7.1-factory-team-bearings-4-asc31734/p537147
2x 5x10x4mm Bearing (Inside of the hub) https://www.amainhobbies.com/team-associated-5x10x4mm-ball-bearing-2-asc25237/p26020
TC6 Crush Tube https://www.amainhobbies.com/team-associated-axle-crush-tube-set-4-asc31370/p220328
TC6 New wheel Hex (not needed but recommended) https://www.amainhobbies.com/team-associated-factory-team-clamping-wheel-hex-blue-4-asc31234/p21979
As manufacturing takes a while, It is recomended to buy a spare set when you order your first set. Arms are reversable so can be used on either side.