Raspberry Pi CASE 1.0 NO LOGO

The same case as "Raspberry Pi CASE 1.0" (http://shpws.me/ooGN) but without the Raspberry Pi logo on top. You can apply your own sticky logo (27.5 x 27.5 mm, R5 rounded square) in the center. Features: - snap-fit fixing system for the board, easy to mount/unmount; - snap-fit closing system, no screw required; - bottom holes for blocking the computer by screws (sliding mount); - led lightguides (not included in this model, available here: http://shpws.me/6yFP ); - pre-shaped hole for GPIO access, just cut it out to open. In this page you can find a gallery of shots working cases by enthusiast users! http://marcoalici.wordpress.com/raspberry-pi-case-gallery/