Black Natural Versatile Plastic
WarSabers Katarn V3 Chassis Proffie P1
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$22.58
Basic Materials Best Value
Shop Owner Recommendations
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
Chassis for the WarSabers Katarn V3 hilts.
This is a permanent wired in battery design, not removable.
You will require parts P2, P3, P4, P5, P6, P7, P8 & P9 to complete this chassis.
This chassis is designed for use with:
-Proffie Board
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm recharge port
-Two Crystals or two of my Generic Kyber Crystal parts, available on shapeways, each with single neopixel
-Two Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-Shtok Blade side PCB (most likely requires sanding down on the outside diameter)
-1.5mm dia brass rod (2-off 51mm long, 2-off 27.5mm long & 1-off 20.2mm long)
-Two 4x4x1.5mm tactile switches
This install is not for the faint of heart, lending itself to true masters of installation, with experience, knowledge and time to achieve one of the best looking 3D printed, double crystal chassis for this hilt.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then the crystal requires gluing into the chassis once everything is wired up and tested.
Once everything is checked and the crystals are glued in place, the two main chassis can be assembled.
This design allows for the board to slide into place once wired up and tested. We recommend fitting on the brass wiring and board covers at the very end.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
This is a permanent wired in battery design, not removable.
You will require parts P2, P3, P4, P5, P6, P7, P8 & P9 to complete this chassis.
This chassis is designed for use with:
-Proffie Board
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm recharge port
-Two Crystals or two of my Generic Kyber Crystal parts, available on shapeways, each with single neopixel
-Two Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-Shtok Blade side PCB (most likely requires sanding down on the outside diameter)
-1.5mm dia brass rod (2-off 51mm long, 2-off 27.5mm long & 1-off 20.2mm long)
-Two 4x4x1.5mm tactile switches
This install is not for the faint of heart, lending itself to true masters of installation, with experience, knowledge and time to achieve one of the best looking 3D printed, double crystal chassis for this hilt.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then the crystal requires gluing into the chassis once everything is wired up and tested.
Once everything is checked and the crystals are glued in place, the two main chassis can be assembled.
This design allows for the board to slide into place once wired up and tested. We recommend fitting on the brass wiring and board covers at the very end.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
Details
What's in the box:
Jimmy's Lightsaber Junk WarSabers Katarn V3 Proffi
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
