Korbanth Katarn V2 Chassis P1

Chassis for the Korbanth Katarn V2 hilts.
This is a permanent wired in battery design, not removable.

For this chassis you will also require P2 & P3 of the design.

This chassis is designed for use with:
-Proffie Board, GHV3 or Verso (dependant on which P2 listing you purchase)
-Two 4x4x5 metal momentary SMD PCB switches
https://www.ebay.co.uk/itm/5-x-4x4mm-SMD-Micro-Momentary-Tactile-Tact-Push-Button-Switch-4Pin-Surface-Mount/362591673561?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm x 5.5mm PCB laptop style recharge port (rectangular front)
-Shtok 10 pole PCB connector set (most likely requires sanding down on the outside diameter)
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-KR blade magnet

This design allows for the board to slide into place once wired up and tested.
The recharge port requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it.

 Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.