forward motor mount for Axial SCX10 1 trans
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$30.00
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
This one piece front motor mount allowes to weight balance your car more forward and lower center of gravity than stock. It might requires custom bent links or some changes to the frame of your rig. It is meant for custom build performance rigs.
Attention: for use in combination with the stock plastic SCX10-1 tranny housing some little adjustments of the inner diameter (spur shaft) is neccessary.
I highly recommend front axle with diff offset, otherwise the drive shaft will touch the motor.
Due to the almost mid chassis position of the motor a 4-link setup should be possible .
It should resist motor heat up to 60°C. i did not find out yet!!
You also need:
Axial AX30665 Spur gear 80t
Pinion 13-15 t
Attention: for use in combination with the stock plastic SCX10-1 tranny housing some little adjustments of the inner diameter (spur shaft) is neccessary.
I highly recommend front axle with diff offset, otherwise the drive shaft will touch the motor.
Due to the almost mid chassis position of the motor a 4-link setup should be possible .
It should resist motor heat up to 60°C. i did not find out yet!!
You also need:
Axial AX30665 Spur gear 80t
Pinion 13-15 t
Details
What's in the box:
Motorhalter_neu_24_06_20
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
