To me this looks classy as its got a clean and almost retro look to it.
Specifically designed and fitted to an RC4WD Chevy Blazer body.
Remove the light buckets form the grill and smooth out any remaining printing supports.
You will need 4 M2x8mm screws to mount the light buckets to the grill.
the buckets were designed to use these LED's pecifically which run on 2 or 3s. The smallest ones are 18 LED's and sold in packs of 4, are very affordable and quite bright.
https://www.aliexpress.com/item/1005001764260566.html?spm=a2g0s.9042311.0.0.3da64c4dpScz9x
They have an adhesive backing and be installed right into the bucket and then the bucker installed on the gril but only once the grill is installed on the body.
So install the grill onto the body using 2 M3x10mm screws, then install the LED's into the bucket and then the buckets onto the grill.
P.S.
The test print shown is from my printer at home. The shapeays prints are MUCH MUCH Smoother and don't show layers