Product Description
This part is a camera mount for OsmoAction designed for FAST helmets using NVG mounts.
In survival games, I used a camera mount that supported a typical NVG mount, often changing the head camera against a tree branch in the bush.
Therefore, in an attempt to lower the mounting position, I used a hanging mount, but the scope and camera often interfere with the short scope of eye relief,
I abandoned the use.
In order to make the mount more intermediate, we repeated trial and error, but the camera protruded forward and did not produce satisfactory results, so we designed it for a 3D printer this time.
The features of this part are as follows.
・This mount is lower than a typical NVG mount and is slightly higher than a suspended mount.
・The angle is fixed and is about -1 degree relative to the side rail.
・During installation, it is locked using the bungee cord supplied with the fast helmet.
・The left side supports the installation of general-purpose USB magnet charging terminals.
・Two separate M3x20 or 25mm screws are required to use this mount.
* Preparation of two M3x20 or 25mm screws is required.
How to make it
1.Match the connection between the camera holder and the fixing buckle.
2.Attach the M3 screws from the left and right to secure them.
How to fix the camera
1.When the buckle is lowered, the top and bottom swallows are pushed up and down to secure it.
2.Pull the pushed buckle with a bungee cord.
release Note
V19 Prottype Test
V22 fixed WIllcox type NVG Mount
V23 Fixed populer Fast Helnet type NVG Mount
V29 MoreUnder Deg 1 →Deg2.
Resize tha holder for Small.
Fixed tha Lock Backle.