Enclosure for pimoroni HyperPixel 2.1 Round Touch* (480x480 pixels (~229 PPI)
) and raspberry pi zero.
collection of cases/parts for this screen
You will need an
angled micro USB cable
Check out videos
If you trust your 3d printer
print it by yourself
Important: don't tighten the screws all the way otherwise screen module may peel off from PCB
WARNING: WHEN INSTALLING HYPERPIXEL 4.0 ROUND ONTO YOUR PI MAKE SURE NOT TO PRESS DOWN ON THE SCREEN SURFACE! HOLD THE BOARD BY ITS EDGES AND WIGGLE IT TO MATE WITH THE EXTENDED HEADER (OR GPIO HEADER). ALSO TAKE CARE NOT TO PULL ON THE EDGES OF THE GLASS DISPLAY WHEN REMOVING YOUR HYPERPIXEL.
Buy Me A Coffee: https://www.buymeacoffee.com/printminion