You must be logged in and verified to contact the designer.
Product Description
Chassis for the KR Sabers Flagship hilts.
This is a removable battery design. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
For this chassis you will also require P2 of the design.
This chassis is designed for use with:
-Proffie Board
-KR Sabers 24mm Bass speaker
-18650 Lithium Ion Battery
-4.3mm tactile switch
-Crystal or my generic chassis crystal (found on shapeways) and single neo pixel
For those who want an aux switch and are willing to increase the diameter of the pilot hole on the hilt, this chassis allows for a tactile switch and a small printed "top hat" plunger is attached to this print hanging out of the speaker (you will need to remove this from the chassis very carefully). Sand the back of the top hat and/or back of the switch to get the feedback your desire from the switch.
The single pixel requires gluing into the crystal once everything is wired up and tested, then the crystal requires gluing into the chamber. This design allows for the board to slide into place once wired up and tested.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: