You must be logged in and verified to contact the designer.
Product Description
Chassis for the Korbanth MPP2.5 hilts.
This is a permanent wired in battery design, not removable.
You will require parts P1 & P3 to complete this chassis.
This chassis is designed for use with:
-Proffie Board or GHV3 (depending on which listing your choose)
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-2.1mm recharge port
-Two Crystals or two of my Generic Kyber Crystal parts, available on shapeways, each with single neopixel
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-KR blade magnet
This install is not for the faint of heart, lending itself to true masters of installation, with experience, knowledge and time to achieve one of the best looking 3D printed, double crystal chassis for this hilt.
The crystal neopixel requires gluing into the crystal once everything is wired up and tested, and then the crystal requires gluing into the chassis once everything is wired up and tested.
Once everything is checked and the crystals are glued in place, the main crystal chamber can be glued to the main chassis.
This design allows for the board to slide into place once wired up and tested. We recommend this as the final step.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: