HYDRAULIC/ELECTRICAL CONNECTORS SET A: 1:48 & 1:32

Adding brake lines or hydraulic lines to  your models can lift them from being a good model to a great model. 
Use small gauge wire to simulate the hydraulilc lines then use these valves to connect lines wherever needed.
This is a set of generic hydraulic valves which can be used on aircraft, helicopters, vehicles etc - anywhere that hydraulic lines are needed.  
These valves can also be used as Electrical connectors

Set A contains the following:

• 51 x 2 Way Valve (straight thru)
• 34 x 3 Way "T" Valve
• 34 x 3 Way "Y" Valve
• 34 x 4 Way Valve (type 1)
• 18 x 4 Way Valve (type 2)

​
Sizes range from Ø1.44mm x 4mm high for the 2 Way Valve to Ø1.25mm x 4mm x 4mm for the 4 Way Valve
Each valve has a small indent at the connecting point to aid as a drilling guide when attaching wires as the hydraulic lines. 
Care must be taken when drilling as the plastic can be quite brittle, especially in thin wall areas.

While primarily aimed at 1:48 scale, this set can also be used on 1:32 scale