You must be logged in and verified to contact the designer.
Product Description
Chassis for the Korbanth Mara Jade hilts. This is a 0% mark up chassis, I make zero profit on this as a thank you to those who purchased the hilt, contributing to Shannon's medical bills.
This is a permanent wired in battery design, not removable.
For this chassis you will also require P2, P3, P4, P5, P6, P7 & P8 of the design.
This chassis is designed for use with:
-Proffie Board
-KR Sabers 28mm Bass speaker
-18650 Lithium Ion Battery
-High Amp (6A) 1.3mm recharge port
-A crystal or my generic chassis crystal (found on shapeways) and single neo pixel
-High Amp kill switch
-Shtok speaker PCB set
-Shtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-3mm metal tube (cut to length between 37-39mm)
-1.5mm brass rod (cut to length between 26.5-26mm)
-four 2mm x 2mm dia neo magnets (optional for the speaker area)
This design allows for the board to slide into place once wired up and tested.
Once the crystal is wired up and tested, the crystal requires being trapped and glued into the two halfs of the crystal chamber as they are assembled in to the chassis.
The recharge port requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue from behind to secure it.
The kill switch requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue from behind to secure it.
The Shtok speaker PCB set requires gluing in to place once everything is wired up and tested.
Plan your wiring ahead of time!
Most items in this chassis are meant to be a tight fit
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: