DSB class Bns cab car N scale

DSB Bns vogn Dette er en del af et sæt til at lave en DSB Bns styrevogn vogn i skala 1:160 "N". Bns og Bn vogne var populære regionaltogs vogne i Danmark fra 1971 til 2010 Bns vognene blev brugt som styrvogne i tog med Bn vogne. Førehuset sidder oppe under taget for at give plads til en mellemgang så toget kan forlænges uden at man behøver at tage styrevognen ud, dog blev denne mellemgang senere blendet af, i sættet er der også en blændeplade så man kan samle den i begge versioner. Kort vejledning: Husk at bestille vinduer til vognen også! Vognen kommer som ubemalet 3D print med en del voks fra printe processen, du renser 3D printet med en ultralydsrenser eller med vand fra den varme hane og sulfo til der ikke er mere voks på plasticken, derefter grunder du 3d printet med en almindelig plastic grunder slib forsigtig indersiden af vinduer samt vognsider der hvor man kan se lag fra 3d printningen til du får en glat og realistisk overflade, pas på at du ikke kommer til at slibe detaljer væk, brug eventuelt en strimmel korn 250 sandpapir holdt mod modelen med en finger, sprøjt et til lag grunder på, hvis overfladen er tilfredsstillende kan vognen males med RAL 3003 "Designrød" Undervognen males RAL 8019 (eller sort for "maroon" udgaven.) Litreringer kan fåes hos Skilteskoven, Du skal bruge 2 styks Roco Minden Deutz boggier de fåes her. Du skal også bruge 2 styks af disse koplingskuliser: Kurzkupplungskulisse www.peho-kkk.de, Order Nr. 005 Husk også Vinduer
______________________________________________________________________________________________

DSB Bns wagon This is part of a set to make a DSB Bns controll car in 1: 160 "N" scale. Bns and Bn cars were popular regional train carriages in Denmark from 1971 to 2010 Bns carriages were used as controll cars in trains that consisted mainly of Bn cars. The drivers cab is located under the roof to make room for a passage gangway so the train can be extended without the need to take control car out, however, that option was later removed and the door was covered, there is also a plate for covering the door in the kit so you can assemble it in both versions. A little Guide: Remember to order windows too! The car comes as unpainted 3D printing with some wax from the print process, cleanin the 3D print with an ultrasonic cleaner or with water from the hot tap and detergent until no more wax can bee seen or felt on the surface, treat the 3D print with an ordinary plastic primer sand careful between the windows and on the flat surfaces where you can see layers from the 3D printing until you get a smooth and realistic surface, beware that you are not going to sand details away, you can use a strip of grain 250 sandpaper held against the model with a finger, spray primer, and sand the surface till the surface is looking satisfying. then paint it red with RAL 3003 "Designrød" Decals can be acquired at Skilteskoven.dk You will need 2 pcs of Roco Minden Deutz bogies the is available here. You also need 2 pcs of these coupler holders: Kurzkupplungskulisse www.peho-kkk.de, Order No. 005 Remember to get Windows.