You must be logged in and verified to contact the designer.
Product Description
Chassis for the KR Sabers Thrawn Hunter hilts.
This is a removable battery design although you can still hard wire a battery in without the battery tabs, entirely up to you. The battery tabs required are the type shown in the link below:
https://www.ebay.co.uk/itm/20Pairs-18650-Battery-Negative-to-Positive-Conversion-Spring-Contact-16-5mmx16mm/362591431441?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
This chassis is designed for use with:
-Two GHV3
-Two KR Sabers 24/22mm Bass speaker
-Two18650 Lithium Ion Battery Button Top or wired (up to you how you want to install these)
-TwoShtok Short Pin Hilt side LED PCB (most likely requires sanding down on the outside diameter)
-Two 4x4x1.5mm SMD metal tactile switches
After wires are soldered to the included battery tabs, I suggest carefully heating up the battery tabs to insert them in to the chassis. This not only makes it a lot easier to insert them, but also forms the plastic around them, holding them far better.
This design allows for the board to slide into place once wired up and tested.
Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: