Black Natural Versatile Plastic
Berg Rear Case
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$60.13
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
This is a Enroute Berg rear case. Its motor is mounted on the opposite side of normal berg. Choose carefully before you order it. It requires the following parts to complate the rear axle:
This is NOT a bolt on option, it required some fabrication and skill to make it all fit.
This Berg Front Case created by Jayden Hocking. I am just selling this on behalf of him.
- Gear - Stock, RCBro, RC4WD. Not Dlux SAF gear (both STD or Low Ratio) as the large second wont fit.
- Tube - 12mm OD tube, it can be made with Aluminium, CF, Delrin, or mixture of materials to achieve the characteristics you are after;
- Upper Link mount - make your own using CF or ally plate. You may also need a motor spacer if you are not using small OD motor.
- Lower link mount - any of the tube link mount for 12mm OD tube would be fine.
- Lock out or bearing cap - to suit 12mm OD tube, there are some in my Shapeways shop.
- Shaft - adjust the length of the tube to get the desire width and stye of shaft.
This is NOT a bolt on option, it required some fabrication and skill to make it all fit.
This Berg Front Case created by Jayden Hocking. I am just selling this on behalf of him.
Details
What's in the box:
rear complete
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
