Enclosure for pimoroni HyperPixel 4.0 Rectangle Touch* (800x480 pixels (~235 PPI)
) and raspberry pi zero.
* it will not fit with HyperPixel 4.0 Rectangle Non-Touch
collection of cases/parts for this screen
You will need an
angled micro USB cable
You may want buy parts in different colors:
Check out
video
Checkout printed version for audio piCorePlayer project: https://forums.slimdevices.com/showthread.php?114625-piTouch&p=1030452&viewfull=1#post1030452
You will need a small peace of foam in order to keep display in place.
I used the
tesa powerbond (remove protective film only from one side).
WARNING: WHEN INSTALLING HYPERPIXEL 4.0 RECTANGLE ONTO YOUR PI MAKE SURE NOT TO PRESS DOWN ON THE SCREEN SURFACE! HOLD THE BOARD BY ITS EDGES AND WIGGLE IT TO MATE WITH THE EXTENDED HEADER (OR GPIO HEADER). ALSO TAKE CARE NOT TO PULL ON THE EDGES OF THE GLASS DISPLAY WHEN REMOVING YOUR HYPERPIXEL.
Buy Me A Coffee: https://www.buymeacoffee.com/printminion