You must be logged in and verified to contact the designer.
Product Description
I couldn't get a new front sight for my Morini CM162e air pistol anywhere so I measured it up and did it myself. I measured it off the "old version" with 1x15v battery but I'm sure it would fit any Morini CM162 (electronic or manual). This is the 3rd version as I finetuned the measurements to make it a direct replacement. I had to change tiny things like the screw hole being a fraction tight or the height being slightly off.
I'm currently using one of the on my Morini (4.5mm wide I think I printed for myself) and I didn't even have to adjust the rear sight!
I've used ring sizes to represent the sight width. Height is approx 7mm - pretty much the same as the original factory sight.
3/44 is 3mm wide
3.5 / 45.25 is 3.5mm wide
4/46.5 is 4mm wide
4.5 / 47.75 is 4.5mm wide
5/49 is 5mm wide
5.5 / 50.25 is 5.5mm wide
6 / 51.5 is 6mm wide
10 / 61.5 is 5mm wide but about 2mm taller than all of the other versions.
10.25 /62.125 is 3mm wide and approx 1mm taller than my originals
10.5 /62.75 is 3.5mm wide and approx 1mm taller than my originals
12 / 66.5 is 4.5mm wide and approx 1.4mm taller
Please check the height (the model will tell you the total height) - I've had a few people order and my sight has been shorter than their stock ones. I can customize to any height, so it is not a problem, but better to check first. If worried, perhaps print 1 in plastic before doing it in metal. I'll lower my markup on plastic versions to make this more attractive.
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: