Tarot T2D Mount - DIY Mounting

New version coming soon to mount the controller.

This is a DIY motor mount for the Tarot T2D.  If you have a flat piece of material in the front of your multirotor this piece can be easily adapted to fit.  There is no mount for the controller so that is left to you to figure out on this version.  The mount requires four rubber vibration isolators and I recommend two locks for the isolators plus two ear plugs.  There is plenty of room on the back plate to drill mounting holes and to trim to fit your model.

Directions:  Figure out how you are going to mount the back plate to the multirotor.  Install the four rubber isolators into the front and back plates.  Install the locks into the top two isolators.  Install ear plugs in the bottom two isolators and trim away excess.  Now you can install the gimbal first or install the plate first.  To install the gimbal onto the front plate: wrap a single layer of tape around the back gimbal motor.  Press motor into front plate and line up the motor with the plate.  Install a screw in the side and/or bottom.  Finish installation and your set!!