You must be logged in and verified to contact the designer.
Product Description
This is the Regulator axle tube. This part has 2 hole locations to give trucks caster at 2.5 degree and need to be matched left to right and front and rear. 2 parts of each are required per section build. In order to build a complete Regulator transmission case with ladder bars, axle tubes, steering blocks, link connectors, and connector bar support, the following parts will be required.
3D print Regulator transmission case - wide 2
3D print Regulator transmission case - narrow 2
3D print Regulator lower link - left 2
3D print Regulator lower link - right 2
3D print Regulator 4-link connector bar - idle 2
3D print Regulator 4-link connector bar - connected 2
3D print Regulator ladder bar closure 4
3D print Regulator axle tube 4
3D print Regulator steering knuckle 4
3D print Regulator transmission to connector bar support 2