One color Enclosure for pimoroni
HyperPixel 4.0 Square Non-Touch* (720x720 pixels (~254 PPI)) and
raspberry pi zero.
* it will
not fit with
HyperPixel 4.0 Square Touch
collection of cases/parts for this screen
You may want buy parts in different colors:
Check out
assembly video
You will need a small peace of foam in order to keep display in place.
I used the
tesa powerbond (remove protective film only from one side).
WARNING: WHEN INSTALLING HYPERPIXEL 4.0 SQUARE ONTO YOUR PI MAKE SURE NOT TO PRESS DOWN ON THE SCREEN SURFACE! HOLD THE BOARD BY ITS EDGES AND WIGGLE IT TO MATE WITH THE EXTENDED HEADER (OR GPIO HEADER). ALSO TAKE CARE NOT TO PULL ON THE EDGES OF THE GLASS DISPLAY WHEN REMOVING YOUR HYPERPIXEL.
Buy Me A Coffee: https://www.buymeacoffee.com/printminion