The
Spinning Plasma Gate is a
Part 01 version. Part 01 is generally the connection between crystal chamber and emitter (blade holder). The
Part 01 SPG contains a spinning part
, which runs by a small 6mm motor.
All Part 01 variations are compatible with ALL mb-sabers Graflex chassis systems! The Part 01 SPG can be used with all standard or Metal Master Graflex chassis. An older Part 01 version can easily be replaced !
The
Part 01 SPG cast metal version consists of
6 3D-printed parts.
The
Part 01 SPG steel version consists of
8 3D-printed parts.
For better orientation all parts are shown on an
information picture here in the shop gallery.
All 3D-printed parts in the respective shop section for
SPG (steel or cast metal) are necessary to assemble the
Part 01 SPG.
Additional parts are also required!
These parts (motor, tubes, threaded rods, nuts) are listed in the manual at
mb-sabers.com