You must be logged in and verified to contact the designer.
Product Description
Universal Chassis-36mm Steer (INL,Multi,Sphl bush) - Rear uses spherical bushes (Slot It CH56b), see video click here. - Inline config - Takes the slim can motor (Shaft lengths 8, 10 & 14mm) - Takes the S-Can motor, endbell drive. - Takes the Boxer / Flat motor. - Takes the short can motor with 8mm shaft. - Takes the short can motor with 12mm shaft. - Chassis rear width 24mm. - Rear ride height adjustment of 1.5mm, using M2 grub screws. - Wheelbase 95mm (max) & 62mm (min) after trimming. - Screws needed: M2.2 screws for Body posts & fixing nuts. M2 grub screws for ride height adjustment & mounting motor brackets.
- Slim can motor’s use motor brackets 1 & 2. - Motor bracket #1 used for front of motor & bracket #2 used for rear of motor. - Slim motor with 8mm shaft uses holes 2 & 5. - Slim motor with 10mm shaft uses holes 3 & 6. - Slim motor with 14mm shaft uses holes 4 & 7. - Boxer/Flat motor’s use motor brackets 3 & 4. - Motor bracket #3 used for front of motor & bracket #4 used for rear of motor. - Boxer/Flat motor brackets use holes 1 & 5. - 12mm Shaft Short Can motor uses motor brackets 3 & 5. - Motor bracket #3 used for front of motor & bracket #5 used for rear of motor. - 12mm Shaft Short Can motor brackets use holes 3 & 7. - 8mm Shaft Short Can motor uses motor brackets 3 & 4. - Motor bracket #3 used for front of motor & bracket #4 used for rear of motor. - 8mm Shaft Short Can motor brackets use holes 1 & 5. - S-Can motor uses motor brackets 6 & 7. - Motor bracket #6 used for front of motor & bracket #7 used for rear of motor. - S-Can motor bracket #6 uses holes 1 & 2. - S-Can motor bracket #7 uses holes 6 & 7.
- Screw set needed for front end assembly, available in the “Parts - JA Slots” section, click here. (Parts include: 3x M2.2x12mm Screws, 2x M2.2x6mm Screws, 2x 12.5mm Stub Axles(3/32) in Steel, S/S or PA12). - Washers can be assembled above or below the hubs for some height adjustment. - Motor wire fixing under the front axle. - Some trimming may be needed due to the nature of 3D printing. Parts Included: 1x Front Steering End 1x Left & Right hubs 1x Bracket Arm 1x Guide 2x 1mm Washers 1x Rear End 2x Fixing Nuts 2x Body Posts General Material Notes: Colors are slightly more flexible then Black, White is slightly more flexible then colors. (Ref: JA99)
We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers: