Polished Bronzed-Silver Steel
Part 01 SPG back steel
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$61.00
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
The Spinning Plasma Gate is a Part 01 version. Part 01 is generally the connection between crystal chamber and emitter (blade holder). The Part 01 SPG contains a spinning part, which runs by a small 6mm motor.
All Part 01 variations are compatible with ALL mb-sabers Graflex chassis systems! The Part 01 SPG can be used with all standard or Metal Master Graflex chassis. An older Part 01 version can easily be replaced ! The Part 01 SPG cast metal version consists of 6 3D-printed parts.
The Part 01 SPG steel version consists of 8 3D-printed parts.
For better orientation all parts are shown on an information picture here in the shop gallery.
All 3D-printed parts in the respective shop section for SPG (steel or cast metal) are necessary to assemble the Part 01 SPG.
Additional parts are also required!
These parts (motor, tubes, threaded rods, nuts) are listed in the manual at mb-sabers.com
All Part 01 variations are compatible with ALL mb-sabers Graflex chassis systems! The Part 01 SPG can be used with all standard or Metal Master Graflex chassis. An older Part 01 version can easily be replaced !
The Part 01 SPG steel version consists of 8 3D-printed parts.
For better orientation all parts are shown on an information picture here in the shop gallery.
All 3D-printed parts in the respective shop section for SPG (steel or cast metal) are necessary to assemble the Part 01 SPG.
Additional parts are also required!
These parts (motor, tubes, threaded rods, nuts) are listed in the manual at mb-sabers.com
Details
What's in the box:
part01_Mag_back_steel_160424
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
More From This Shop
$6.00
$15.00
$70.00
