In this project, the objective was to build a FPV flying wing with over 700mm wingspan that could be printed under 24 hours at 0.2mm layer height and is easily Assembled. The drone comprise of only 8 parts. You do not need a flight controller or anything else to run FPV on this model.
3D Printed Parts
-2 Elevons
-2 Wing Tips
-2 Wings
-1 Fuselage
-1 CanopyElectronics
- 2 x Servos Motor 9g
https://amzn.to/3H0UXK0
- A2212 Motor (1000kv or 2000kv)
https://amzn.to/3xfTElX
- 1 x 30 Amps ESC
https://amzn.to/3xmMmxV
-Micro FPV Camera Kit (with transmitter and receiver)
https://amzn.to/3GW10zj
-RC Transmitter/Receiver
https://amzn.to/3Mw279T
-6045 Propeller
https://amzn.to/3mkzVfR
Tools
-3D Printer (With one Axis larger than 250mm)
https://amzn.to/3NvBZxe
-Hot glue Gun & Sticks
https://amzn.to/3NXmv5c
-Cyanoacrylate glue
https://amzn.to/3aAUoKo
-RC elevon rods
https://amzn.to/3MkCY24
Shapeways only allows me to list the product to be 3D printed in steel but you can get the plastic versions on the link below.
Download all 8 Parts Individually at: https://www.k3d.plus/products/3d-printed-flying-wing-fpv-drone
3D PRINTING SETTINGS:0.2mm layer height