Sony ECM-CS3 Helmet Mic Holder (Offset Front)

This holder is the same as the previous version only with less of a curvature on the base to allow mounting left or right of center more easily to the front interior of a full face helmet.

FITMENT: The height of the holder is around 1.75 cm. This is the minimum clearance needed between it and your face once mounted. A close approximation would be to take your middle finger (or thumb if you have smaller hands) and place it between the area you want to mount it too while putting on the helmet to determine clearance.  

Instructions:
1) Remove the hinge pin, spring and upper half from the Sony ECM-CS3's lapel clip
2) Remove the screw and detach the lower half of the lapel clip
3) Replace the screw in the mic housing
4) Locate a suitable location to mount the holder inside the front of your helmet. Affix with 3M double sided VHB foam tape.
5) Slide mic in holder and route cable. Enjoy!

*Notes:
- If you prefere a part in another color not offered, the white polished option may be purchased instead with a bit of DIY elbow grease to dye the part yourself to the color you want. ​
See[u] http://www.instructables.com/id/How-to-Dye-Your-Nylon-3D-Prints/[/u] For Color Dying

- Dyes used for colored components on shapeways (white is uncolored) are water based and need to be sealed with a UV resistant clear coat for maintaining color appearance with exposure outdoors.

- Fiebing's Leather Dye is an alcohol based waterproof alternative but will still require sealing with a UV protective clearcoat for color fastness. You can see their color options here [u]https://www.fiebing.com/wp-content/uploads/2012/08/2016_Color-Chart_Web.jpg[/u]

Model Design © 2017 Sir Burg